|
In the current paper we address edge placement budget generation as well as potential for improved patterning control for an HVM use case at the 28nm litho node. Edge placement and possible related defect mechanisms arise most critically at the contact layer, where contact hole patterning and EPE, with respect to both underlying gate and active layers need to be well controlled. At the 28nm node and for automotive applications, variability control within 5-sigma, i.e. to failure rates below 1 ppm, is generally required to ensure device reliability. To support generation of an EPE budget by wafer data that captures inter and intra-field components, including local stochastic variations, we use a high-throughput, large field-of-view SEM tool from Hermes Microvision, at all three process layers of interest, as well as YieldStar metrology for overlay characterization. The large volume of data being made available -tens of millions of individual CD measurements- allows mapping out the low-probability ends of variability distributions and detecting non-Gaussian ‘fat tails’ indicative of defect rates that would be underestimated by 3-sigma estimates. Data analysis includes decomposing the total pattern variations into sources of variability, such as global CDU, mask variations and local stochastics. In addition to established CD metrology, we apply novel SEM image based analysis of repetitive patterns in SRAM arrays to generate 2-dimensional process variability bands, including estimates of pattern placement. This approach allows to investigate in detail the probabilistic interaction between active, gate and contact layers. |
|
|
