Paper
17 July 1979 A Better Mousetrap
Jack R. Snyder, Jamie Van DeVen
Author Affiliations +
Abstract
With VLSI technology advancement, comes a requirement for increased density, improved resolution, higher device yield, and lower mask cost; the necessary vehicle, of course, appears to be projection or non-contact printing of mask to wafer. Several systems are presently available, including: direct step on wafer, projection alignment, and proximity (shadow projection) alignment. This paper deals with the evaluation and production use of a new proximity printing system, the Sass MjB 55 Shadow projection aligner. Image quality and resolution will be discussed, with slides demonstrating resolution. approaching the one micron limit in positive photoresist and a two micron limit in negative photoresist. Aligner environmental requirements, along with performance in production mode, and operator Hcceptability is included. Wafer requirements, specifically flatness, are shown to be much less stringent than with projection systems, the Suss having very. acceptable critical dimension stability over a range of 20 microns. Throughput figures, both for alignment and non-alignment processing, far exceeds that of all other systems previously evaluated or under consideration for upgrading and improving photolithographic processing. Comparisons of mask degradation and device yield improvement versus con ventional contact printing and projection printing shows the Suss to be equivalent to other available systems. A. unique system of calibrating mask to wafer separation (2.5 micron steps, +1 micron repeatibility), improved viewing optics, and realistic illumination intensity of 2 to 20 milliwatts at better than +2% uniformity, coupled with a new deep-UV source, certainly leads one to believe that we may indeed have found "A Better Mousetrap."
© (1979) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Jack R. Snyder and Jamie Van DeVen "A Better Mousetrap", Proc. SPIE 0174, Developments in Semiconductor Microlithography IV, (17 July 1979); https://doi.org/10.1117/12.957181
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Semiconducting wafers

Photomasks

Optical alignment

Printing

Group IV semiconductors

Semiconductors

Optical lithography

RELATED CONTENT

New Generation Of 1:1 Optical Projection Mask Aligners
Proceedings of SPIE (July 17 1979)
Projection Printing Characterization
Proceedings of SPIE (August 08 1977)
Double-Sided Photolithography
Proceedings of SPIE (September 06 1978)
Is it possible to improve MEEF?
Proceedings of SPIE (July 30 2002)
Prototype photomasksâ€"a low-cost alternative
Proceedings of SPIE (July 17 1979)

Back to Top