Laser cutting of titanium with pulsed and modulated pulsed Nd:YAG lasers

Warren Maher; Kwok-On Tong

doi:10.1117/12.308671

27 May 1998 Laser cutting of titanium with pulsed and modulated pulsed Nd:YAG lasers

Warren Maher, Kwok-On Tong

Proceedings Volume 3265, Solid State Lasers VII; (1998) https://doi.org/10.1117/12.308671
Event: Optoelectronics and High-Power Lasers and Applications, 1998, San Jose, CA, United States

Abstract

Recent test results demonstrate the differences between laser cutting of Ti with different pulsed formats at 1.06 micrometer wavelength. The precision Laser Machining (PLM) consortium is dedicated to investigating improved processing obtained with the use of diode-pumped Nd:YAG lasers having high beam quality and high average power. One of the PLM lasers developed at TRW was used to determine the best parameters for laser cutting 0.034' Ti. Average power was available up to 340 W. Pulse repetition rates were 322 Hz with pulse lengths of 454 microseconds, while the modulated laser output had a 142 kHz micropulse train within the pulse envelope. Beam quality was sufficient to permit a 100 micrometer spot size to be used with f/10 focusing. Ar assist gas was used. At each setting of the laser average power the cutting tests usually were tried at 11 different speeds, up to 3'/second. The highest speed for which cutting is possible at a given average power is the threshold speed for that power. The cut specimens were evaluated for dross for a variety of rear surface Ar cross flow conditions. Each cut specimen also was evaluated for excess heating indicated by metallurgical and/or surface chemistry changes. Cutting at speeds above a critical minimum speed for each setting of laser average power greatly reduces degradation due to excess heating. Good cutting is possible between the threshold speed and this minimum speed (both a function of average power). Data for threshold and minimum speed were obtained for the pulsed and the modulated pulsed laser output. These tests also determined evidence of optimum conditions for cutting with a rear cross flow of Ar that substantially eliminates rear surface dross on the edge of the kerf. The quality of the cut edge was evaluated by inspection of its polished cross-section.

Citation Download Citation

Warren Maher and Kwok-On Tong "Laser cutting of titanium with pulsed and modulated pulsed Nd:YAG lasers", Proc. SPIE 3265, Solid State Lasers VII, (27 May 1998); https://doi.org/10.1117/12.308671

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE

Includes PDF, HTML & Video, when available