Paper
14 January 2000 Laser processing of metal surfaces for increasing paint adhesion
Tomiyasu Hirose, Hideki Ichihara, Kenji Sugimoto, Kazuo Sasazawa, Shouji Shibasaki
Author Affiliations +
Proceedings Volume 3887, High-Power Lasers in Civil Engineering and Architecture; (2000) https://doi.org/10.1117/12.375196
Event: Advanced High-Power Lasers and Applications, 1999, Osaka, Japan
Abstract
Painted metal exteriors of buildings begin to degrade in about 10 years due to solar heat, UV rays, the sea salt adhesion, the acid rain etc. When degradation and exfoliation of the paint film occurs, rust appears in the metal and replacement or repainting becomes necessary. The adhesion of paints on metal is usually achieved by chemical adhesion or by increasing the surface area by blast processing. In this study, the possibility of improving paint adhesion by forming minute holes on the metal surface by laser irradiation was studied through modeling of the adhesion of the paint film and adaptability to deformation. The viscosity and painting method depend on the size and location of the oles. The presence of the holes makes it possible to form complicated shapes by pressing because the holes absorb some of the strain caused by pressing.
© (2000) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Tomiyasu Hirose, Hideki Ichihara, Kenji Sugimoto, Kazuo Sasazawa, and Shouji Shibasaki "Laser processing of metal surfaces for increasing paint adhesion", Proc. SPIE 3887, High-Power Lasers in Civil Engineering and Architecture, (14 January 2000); https://doi.org/10.1117/12.375196
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Metals

Coating

Buildings

Laser irradiation

Laser processing

Computer aided design

Ultraviolet radiation

RELATED CONTENT

Strategic directions of laser technologies development
Proceedings of SPIE (January 20 1999)
Biocompatible metallic stent for medical therapy
Proceedings of SPIE (December 12 2003)
Increase of hole drilling speed by using packs of laser...
Proceedings of SPIE (September 20 1999)
Processing of ceramics by excimer lasers
Proceedings of SPIE (August 01 1990)

Back to Top