Paper
9 November 1999 Micromirror actuation with electrostatic force and plate bending
Seungoh Han, HoJoon Park, James Jungho Pak
Author Affiliations +
Abstract
In this paper, a new method for actuating micro-mirrors, which utilizes bending of the micro-mirror plate, was proposed in order to increase the rotational angle without increasing the sacrificial layer thickness. The analytical model of the proposed actuating method was established and, based on the analytical model, the expected micro-mirror operation is presented. In order to confirm the expected operation surface-micromachined polysilicon micro-mirror operation is presented. In order to confirm the expected operation surface micromachined polysilicon micro-mirror was fabricated and tested. The bending of the micro-mirror plate, however, was not observed in the experiment with the fabricated micro-mirror. There are two possible reasons for this. One is the driving force reduction due to the decreasing of the voltage difference between the micro- mirror plate and underlying electrode caused by electrical conducting between the two. The other is the non-optimized design in the mechanical structure which caused the bending of the supporting beam before the plate starts to bend.
© (1999) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Seungoh Han, HoJoon Park, and James Jungho Pak "Micromirror actuation with electrostatic force and plate bending", Proc. SPIE 3899, Photonics Technology into the 21st Century: Semiconductors, Microstructures, and Nanostructures, (9 November 1999); https://doi.org/10.1117/12.369383
Lens.org Logo
CITATIONS
Cited by 2 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Micromirrors

Mirrors

Electrodes

Actuators

Mechanical engineering

3D metrology

Low pressure chemical vapor deposition

Back to Top