Paper
23 October 2002 Transparent conducting coatings on glass tubes
Author Affiliations +
Abstract
The conventional dip coating techinques, as it is used for flat surfaces, cannot be applied to deposit homogeneous coatings in optical quality inside tubes. The resulting coatings exhibit large variations in thickness and roughness over the length of the tube and show a morphology with a network of cracks. The main reason for these problems seem to be a delayed and restricted solvent evaporation due to the impediment of a laminar flow and the progressive saturation of the atmosphere in the tube. A modified dip coating technique was therefore developed to allow forced flow conditions inside the tubes by an additional exhausting tube. By means of this modification transparent conducting coatings of sol-gel SnO2:Sb (antimony-doped tin oxide - ATO) could be deposited on both sides of borosilicate glass tubes (300 mm, inner diamters down to 11 mm) with excellent thickness uniformity and low roughness (Ra≈1nm). After a heat treatment at temperatures up to 500°C, the prepared ATO coatings are mechanically stable and highly transparent (>85% transmission) with a sheet resistance down to 10 kΩ. The coatings can be used as electrodes for electronic devices and electrical heaters or to give antistatic properties to the substrate.
© (2002) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Joerg Puetz, F. N. Chalvet, and Michel Andre Aegerter "Transparent conducting coatings on glass tubes", Proc. SPIE 4804, Sol-Gel Optics VI, (23 October 2002); https://doi.org/10.1117/12.453905
Lens.org Logo
CITATIONS
Cited by 3 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Optical coatings

Resistance

Sol-gels

Glasses

Thin film coatings

Radium

Heat treatments

Back to Top