Paper
17 November 1986 Automatic Optical Measurement Of Contact Lenses
C J Elliott
Author Affiliations +
Proceedings Volume 0654, Automatic Optical Inspection; (1986) https://doi.org/10.1117/12.938279
Event: 1986 International Symposium/Innsbruck, 1986, Innsbruck, Austria
Abstract
Smith Associates is automating the operation of a contact lens factory. The latest stage of this project involved the development of an automatic radiuscope to measure the properties of the back face of the lens. The equipment developed was based on an existing manual radiuscope. A solid state video camera was installed in place of the eyepiece, and stepper motors used to drive the manual controls. An image processing computer, derived from Smith Associates' PIX system, was used to carry out the image processing and control the stepper motors. The equipment has been in service under factory conditions since mid 1985. It has been found that the measurements made by the equipment are about an order of magnitude more accurate than those made by a person using the same optical system. Also, a number of measurements are made which could not be made manually. These include surface finish, toricity and eccentricity of the back face of the lens.
© (1986) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
C J Elliott "Automatic Optical Measurement Of Contact Lenses", Proc. SPIE 0654, Automatic Optical Inspection, (17 November 1986); https://doi.org/10.1117/12.938279
Lens.org Logo
CITATIONS
Cited by 1 scholarly publication.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Fourier transforms

Image processing

Control systems

Optical inspection

Contact lenses

Polishing

Surface finishing

RELATED CONTENT

To develop a flying fish egg inspection system by a...
Proceedings of SPIE (July 17 2015)
Real-time automatic inspection under adverse conditions
Proceedings of SPIE (March 01 1991)
Estimation of lean and fat composition of pork ham using...
Proceedings of SPIE (January 06 1995)
Computer vision system for three-dimensional inspection
Proceedings of SPIE (November 09 1994)
Vision-based coin inspection system
Proceedings of SPIE (October 31 1996)

Back to Top