Paper
15 May 2014 Limit of detection comparison for surface wave biosensors
Author Affiliations +
Abstract
Bloch surface waves (BSW) propagating at the surface of truncated, one-dimensional crystals are valid candidates to improve sensors based on surface plasmon polaritons, usually referred to as surface plasmon resonance (SPR). The low losses introduced by the dielectric BSW stacks enable to achieve resonance widths much below the ones of SPR, thus proposing improved sensing results. A simplified, bi-linear model of the resonance intensity distribution is applied to estimate the effect of the resonance properties onto the measurement noise. This yields a limit of detection (LoD) that is used to optimize a BSW supporting thin film stack and to quantitatively compare SPR and BSW sensors. The results indicate that an order of magnitude reduction of the LoD is within reach when sufficient sampling of narrow BSW resonances is achieved.
© (2014) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Riccardo Rizzo, Norbert Danz, Francesco Michelotti, Peter Munzert, and Alberto Sinibaldi "Limit of detection comparison for surface wave biosensors", Proc. SPIE 9141, Optical Sensing and Detection III, 91410P (15 May 2014); https://doi.org/10.1117/12.2052297
Lens.org Logo
CITATIONS
Cited by 3 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Sensors

Thin films

Refractive index

Plasmons

Surface plasmons

Biosensors

Crystals

Back to Top