Paper
18 December 2014 Laser shock microforming of aluminum foil with fs laser
Yunxia Ye, Yayun Feng, Ting Xuan, Xijun Hua, Yinqun Hua
Author Affiliations +
Abstract
Laser shock microforming of Aluminum(Al) foil through fs laser has been researched in this paper. The influences of confining layer, clamping method and impact times on induced dent depths were investigated experimentally. Microstructure of fs laser shock forming Al foil was observed through Transmission electron microscopy (TEM). Under the condition of tightly clamping, the dent depths increase with impact times and finally tend to saturating. Another new confining layer, the main component of which is polypropylene, was applied and the confining effect of it is better because of its higher impedance. TEM results show that dislocation is one of the main deformation mechanisms of fs laser shock forming Al foil. Specially, most of dislocations exist in the form of short and discrete dislocation lines. Parallel straight dislocation slip line also were observed. We analyzed that these unique dislocation arrangements are due to fs laser-induced ultra high strain rate.
© (2014) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Yunxia Ye, Yayun Feng, Ting Xuan, Xijun Hua, and Yinqun Hua "Laser shock microforming of aluminum foil with fs laser", Proc. SPIE 9295, International Symposium on Optoelectronic Technology and Application 2014: Laser Materials Processing; and Micro/Nano Technologies, 92950Y (18 December 2014); https://doi.org/10.1117/12.2073215
Lens.org Logo
CITATIONS
Cited by 1 scholarly publication.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Femtosecond phenomena

Aluminum

Adhesives

Transmission electron microscopy

Metals

Pulsed laser operation

Laser processing

Back to Top