Paper
10 May 2016 The impact of the residual stress on the EUV pellicle
Eun-Sang Park, Jae-Keun Choi, Min-Ha Kim, Sollee Hwang, Zahid Hussain Shamsi, Dai-Gyoung Kim, Hye-Keun Oh
Author Affiliations +
Abstract
High resolution patterning on the chip could be achieved by extreme ultraviolet lithography (EUVL). However, the defect on the mask becomes more important issue with very short wavelength (13.5 nm). Using the pellicle which could protect the mask from the defects can support high volume manufacturing (HVM). Most of the materials considered for pellicle have relatively high extinction coefficient in EUV region. Therefore, the thickness of the pellicle should be ~ nm thin. The stress of the pellicle is dependent not only on the temperature but also on the mechanical properties of the pellicle. The stress induced by the gravity was small compared to the thermal stress. However, the residual stress should be also considered since it is dependent on the pellicle manufacturing environment and this stress is comparable with the thermal stress. Our result shows the importance of the lowering the pellicle fabrication temperature in terms of the extending the lifetime during the scanning process.
© (2016) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Eun-Sang Park, Jae-Keun Choi, Min-Ha Kim, Sollee Hwang, Zahid Hussain Shamsi, Dai-Gyoung Kim, and Hye-Keun Oh "The impact of the residual stress on the EUV pellicle", Proc. SPIE 9984, Photomask Japan 2016: XXIII Symposium on Photomask and Next-Generation Lithography Mask Technology, 99840F (10 May 2016); https://doi.org/10.1117/12.2241276
Lens.org Logo
CITATIONS
Cited by 1 scholarly publication.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Pellicles

Extreme ultraviolet

Extreme ultraviolet lithography

Manufacturing

Heat flux

Photomasks

Mirrors

RELATED CONTENT


Back to Top