Paper
1 May 2017 Passive coherent location direct signal suppression using hardware mixing techniques
Sean A. Kaiser, Andrew J. Christianson, Ram M. Narayanan
Author Affiliations +
Abstract
Passive coherent location (PCL) is a radar technique, in which the system uses reflections from opportunistic illumination sources in the environment for detection and tracking. Typically, PCL uses civilian communication transmitters not ideally suited for radar. The physical geometry of PCL is developed on the basis of bistatic radar without control of the transmitter antenna or waveform design. This poses the problem that often the receiver is designed with two antennas and channels, one for reference and one for surveillance. The surveillance channel is also contaminated with the direct signal and thus direct signal suppression (DSS) techniques must be used. This paper proposes an analytical solution based around hardware for DSS which is compared to other methods available in the literature. The methods are tested in varying bistatic geometries and with varying target radar cross section (RCS) and signal-to-noise ratio (SNR).
© (2017) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Sean A. Kaiser, Andrew J. Christianson, and Ram M. Narayanan "Passive coherent location direct signal suppression using hardware mixing techniques", Proc. SPIE 10188, Radar Sensor Technology XXI, 1018802 (1 May 2017); https://doi.org/10.1117/12.2262300
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Signal to noise ratio

Surveillance

Frequency modulation

Linear filtering

Transmitters

Radar

Modulation

Back to Top