Using an active primary surface to correct for low-order manufacturing errors in secondary mirrors of large reflector antennas

German Cortes-Medellin; Amy J. Lovell; Rogerio Enriquez; David R. Smith

doi:10.1117/12.550830

29 September 2004 Using an active primary surface to correct for low-order manufacturing errors in secondary mirrors of large reflector antennas

German Cortes-Medellin, Amy J. Lovell, Rogerio Enriquez, David R. Smith

Author Affiliations +

Proceedings Volume 5495, Astronomical Structures and Mechanisms Technology; (2004) https://doi.org/10.1117/12.550830
Event: SPIE Astronomical Telescopes + Instrumentation, 2004, Glasgow, United Kingdom

Abstract

In the fabrication of high-performance, low-cost secondary reflectors for radio telescopes, it is a significant challenge to avoid introduction of low-order surface errors such as astigmatism or coma. This arises primarily because low-order surface errors are easily induced by support structure placement or simple thermal variations in the manufacturing process. It is, of course, possible to bring these errors to within the required tolerance, but if an active primary reflector is present, it may be possible to relax the requirements on the secondary and perhaps lower its cost. In this paper, we take the Large Millimeter-wave Telescope (LMT/GTM) as an example system. We model the effects of correcting a deformed sub-reflector by using the existing segmented active primary. The sub-reflector deformation patterns employed are low-order (e.g., astigmatism or coma), but are allowed significant excursions from the nominal surface figure. For each case, we demonstrate the best theoretical performance, using the active primary to correct for the errors. Additionally, to determine whether such an approach would be practical, we also demonstrate the likely performance improvement that could be achieved using brief measurements on an astronomical source. In this approach, we introduce varying amounts of known low-order deformation patterns into the active primary and seek the combination that results in the maximum signal. Finally, we compare this result to the theoretical maximum and make recommendations on the practical utility of the approach.

Citation Download Citation

German Cortes-Medellin, Amy J. Lovell, Rogerio Enriquez, and David R. Smith "Using an active primary surface to correct for low-order manufacturing errors in secondary mirrors of large reflector antennas", Proc. SPIE 5495, Astronomical Structures and Mechanisms Technology, (29 September 2004); https://doi.org/10.1117/12.550830

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE

Includes PDF, HTML & Video, when available

Members: $17.00

Non-members: $21.00 ADD TO CART

PROCEEDINGS
11 PAGES

DOWNLOAD PAPER SAVE TO MY LIBRARY

GET CITATION

RIGHTS & PERMISSIONS

Get copyright permission Get copyright permission on Copyright Marketplace

KEYWORDS

Antennas

Monochromatic aberrations

Reflectors

Astronomy

Zernike polynomials

Telescopes

Carbon

Show All Keywords

Keywords/Phrases

Search In:

Publication Years