Paper
11 November 1999 Using linear variable differential transformers and ultrasonic transducers to measure flatness and parallelism for NIF optics
Author Affiliations +
Abstract
Measuring surface figure of large ground surfaces has been done with infrared interferometers or by means of local measurements with a spherometer to obtain a general shape of an optical surface. This paper describes a straightforward technique to obtain surface figure of plano parallel optics with an array of transducers referenced to an optical flat. The instrument utilizes 16 linear variable differential transformers (LVDT) and 16 ultrasonic transducers (UT) to measure surface figure of side 1, side 2 and the wedge in one measurement setup. The transducers are setup in a 4 X 4 array, for a total of 32 in one fixture. The data is acquired via a PC acquiring data through serial ports and an A/D card. The two 4 X 4 data sets are fit to the first ten Zernikes using the method of least squares. The data is displayed with 3D graphics to obtain a view of the optical surfaces. By using 14 bit digital LVDT's and employing the cross correlation technique for acoustic signal processing a system accuracy of plus or minus 1.0 micrometer for the LVDT array and plus or minus 2.75 micrometer for the UT array has been achieved.
© (1999) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Richard J. Boland "Using linear variable differential transformers and ultrasonic transducers to measure flatness and parallelism for NIF optics", Proc. SPIE 3782, Optical Manufacturing and Testing III, (11 November 1999); https://doi.org/10.1117/12.369197
Lens.org Logo
CITATIONS
Cited by 3 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Transducers

Ultrasonics

Surface finishing

Acoustics

Calibration

National Ignition Facility

Optics manufacturing

Back to Top