KEYWORDS: Laser stabilization, Design, Field effect transistors, Control systems, Analog to digital converters, Semiconductor lasers, Field programmable gate arrays, Signal processing, Sampling rates
Narrow line width lasers with high stability are a key enabling technology in high-impact applications such as quantum technologies and laser surgery. On the one hand, stabilizing such lasers implies the design of efficient Proportional-Integral-Derivative (PID) controllers. On the other hand, high end applications require PID controllers with very high regulation bandwidth, relocking feature and easy to adjust parameters. In order to tackle these challenges, we designed and enhanced a PID controller using the pipeline technique. This allowed us to improve the sample rate at which the controller operates. The designed PID has been successfully used in a VBG based external cavity for laser stabilization with ultra-narrow line width.
To meet the requirements for multi-species gas analysis, Quartz-Enhanced Photo-Acoustic Spectroscopy (QEPAS) is used in combination with an IC-based External Cavity Laser system (IC-ECL). The laser system allows the coverage of a wavelength range of 285 nm with an output power of several mW. By integrating piezoelectric actuators as well as resonantly driven MEMS actuators, extremely high sampling rates can be achieved. In this work, results on the detection of multiple trace gases by sequential quasi-simultaneous measurements are presented. The requirements of multi-species detection, output power, tuning range and detection rate are met by our work.
External resonator diode lasers are the appropriate choice for species detection in application areas such as medicine, climate and industry due to their excellent properties, but have limitations in terms of high detection rates and commercial availability in the MIR region. Especially in the MIR region, many molecules have particularly strong absorption bands, which can result in very low detection limits and is therefore of particular interest. In this paper, we present our new ICbased laser chips with straight and curved waveguides with a center wavelength at 3.4 μm. These are integrated into an external resonator setup and characterized. The IC-based system enables continuous wave operation at room temperature over a wavelength range of 285 nm with several mW output power. With respect to the problem of high sampling rates, one promising technique is MEMS technology integrated as a tuning element in the external resonator structure. This enables planar drive control for high-frequency resonance-driven MEMS scanners, where the sampling frequency corresponds to the resonance frequency. These will be tested for their suitability and integrated into an ECDL setup and evaluated. Our work will address new requirements in terms of tuning range, output power, and acquisition rate.
With emerging technologies, which result in more intensive industry and manufacturing, fully portable and multi-gas detectors are increasingly being required on to handle situations where a wider range of hazardous substances may be present and proper detection equipment is essential.
Most gas monitoring devices focus on a single species. However, there are many sensing applications (e.g.: industrial chemical processes) where several gases need monitoring at the same time and with a single detector. In this regard, a novel portable QEPAS (Quartz-Enhanced Photo-Acoustic Spectroscopy) multi-gas detector with non overlapping QTFs (Quartz Tuning Forks) resonance frequencies can help meet these challenges.
The detection and identification of molecular gases are of high relevance in many applications within healthcare, production monitoring and safety as well as environmental monitoring. One of the major difficulties of trace gas analysis is due to the bulky and expensive systems, what excludes both mobile and handheld use. For this purpose we present our new system based on the Quartz Enhanced PhotoAcoustic Spectroscopy (QEPAS), which can provide the required properties for gas analysis. We have developed a compact detection unit where DFB laser, collimation optics and QTF are integrated in a 14-pin butterfly housing. Therefore an optimization of the DFB laser chips will be presented too. The results show, that the laser diodes not only provide excellent performance, but also allow a detection limit for the greenhouse gas methane and carbon dioxide in the ppm range.
Although external cavity diode lasers have become firmly established for their excellent properties for species detection, they have severe limitations in terms of high acquisition rates. In this paper, we present our new ECDL design based on a resonantly driven MEMS scanner. By using the MEMS technology, a defined frequency range can be tuned extremely fast and without mode-hops. This allows scanning frequencies in the high kHz range to be achieved. The results of the characterization of the spectral properties of the MEMS-based system and its use for rapid detection of trace gases are presented.
GaSb based types of diode lasers may cover the spectral regime from below 1.8 μm up to 5 μm. For the wavelength regime of 1.8 μm to 2.5 μm InGaAsSb/GaSb MQW material is used. For 2.5 μm to 3.4 μm InAlGaAsSb/GaSb MQW material is used. For above 3μm, an ICL type of design is required. We realized a growth campaign of 10 GaSb based wavers for covering the wavelength regime from 1.9μm to 3μm. We report on the test, performance and applications results in molecular gas sensing of both, gain chips within an external cavity laser as well as on digital DFB lasers.
The MIR wavelength regime promises lower gas detection limits than the NIR or the VIS region due to higher absorption levels as one can read for simulation listed in HITRAN. Methane shows moderate absorbance below 3 μm which results into detection limits in the range of low ppm. IC and QC based lasers emit higher wavelengths, where the absorbances of methane are higher. TDLAS and QEPAS measurements to the trace gas CH4 are shown to display the spectroscopy performance of the different lasers with and without influences from the detector material. In this manuscript only QEPAS measurements will be presented. Scope of this paper is a quantitative comparison of the absorption and QEPAS behaviour of Methane in four important spectral regimes.
Narrow linewidth tunable diode lasers are an important tool for spectroscopic instrumentation. Conventional external cavity diode lasers are designed as laboratory instrument and do not allow hand-held operation for portable instruments. A new miniaturized type of tunable external cavity tunable diode laser will be presented. The presentation will focus on requirements on the assembly technology of micro-optic components as well as on the physical properties of such devices. Examples for the realization of this new technology will be given in the NIR for Alkaline Spectroscopy as well as in the MIR at 1908nm.
Access to the requested content is limited to institutions that have purchased or subscribe to SPIE eBooks.
You are receiving this notice because your organization may not have SPIE eBooks access.*
*Shibboleth/Open Athens users─please
sign in
to access your institution's subscriptions.
To obtain this item, you may purchase the complete book in print or electronic format on
SPIE.org.
INSTITUTIONAL Select your institution to access the SPIE Digital Library.
PERSONAL Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.