Paper
8 September 1995 Making (lambda)/200 rms spheres via a hybrid conventional/computer-controlled process
Richard J. Boland, John Newcomb, Aaron N. Turner
Author Affiliations +
Abstract
High quality optics have been manufactured using both conventional spindle polishing and small tool figuring under computer control. While both techniques have been used to produce precision optics in the past, this paper describes the hybrid process of using both processes to utilize their specific figuring efficiencies. By knowing the frequency content of the surface being corrected, the proper tool size can be selected to address the dominant frequency. By using the most efficient tool for correction fabrication time will be reduced yielding more cost effective processes. Proper process calibrations and controls are required to maximize convergence and material removal.
© (1995) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Richard J. Boland, John Newcomb, and Aaron N. Turner "Making (lambda)/200 rms spheres via a hybrid conventional/computer-controlled process", Proc. SPIE 2536, Optical Manufacturing and Testing, (8 September 1995); https://doi.org/10.1117/12.218434
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Polishing

Surface finishing

Calibration

Optics manufacturing

Process control

Optical spheres

Spindles

Back to Top