Paper
1 May 1996 Strain-displacement mapping for a precision truss using Bragg gratings and identified mode shapes
Albert Bosse, George C. Kirby III, David G. Bellemore, Alan D. Kersey, Tsung-Ein Tsai, E. Joseph Friebele
Author Affiliations +
Abstract
A procedure for mapping strain measurements to nodal displacements for a 3.74 meter laboratory truss is presented and validated using experimental data. Assumptions of small displacements and a linear displacement-strain relationship were used to develop the strain- displacement mapping. Due to the assumed discrete nature of the space truss structure, the transformation depends only on kinematics and hence only geometric data is required for the mapping. The procedure is therefore valid for quasi-static deformations as well as dynamic deformations. Estimated displacements for several nodes are compared with truth measurements obtained from both a laser interferometer system and accelerometers. It is shown that the accuracy of the predicted displacement for a limited number of sensor depends not only upon the deformation state but also which degree of freedom is being estimated.
© (1996) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Albert Bosse, George C. Kirby III, David G. Bellemore, Alan D. Kersey, Tsung-Ein Tsai, and E. Joseph Friebele "Strain-displacement mapping for a precision truss using Bragg gratings and identified mode shapes", Proc. SPIE 2717, Smart Structures and Materials 1996: Smart Structures and Integrated Systems, (1 May 1996); https://doi.org/10.1117/12.239037
Lens.org Logo
CITATIONS
Cited by 2 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Sensors

Fiber Bragg gratings

Interferometers

Digital signal processing

Laser systems engineering

Antennas

Data acquisition

Back to Top