Paper
20 August 2004 Investigation of Cr defect in high Cr load logic mask
Author Affiliations +
Abstract
In this study, Cr defects resulted from high voltage E-beam writing in high Cr load Logic Mask were investigated. The Cr defect, which is a damage of anti-reflection layer on Cr, is mainly found in isolated Cr patterns of high Cr load Logic Mask. This defect appears under high voltage E-beam writing with high dose and dry etch process. High accelerating voltage and dose of E-beam writing decrease the thickness of remaining E-beam resist after developing. These phenomena are more significant in high Cr load Logic Mask consisted of isolated Cr patterns. Because the resist thickness of isolated Cr pattern is not enough for enduring dry etch process-induced damage, Cr surface is damaged during etching. Consequently, the Cr surface damage of high Cr load Logic Mask is related with voltage and dose of E-beam and dry etch process time. To prevent these defects, low accelerating voltage and dose of E-beam and low thickness of Cr layer to increase dry etch process margin are necessary.
© (2004) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Ho-Yong Jung, Sung Jin Choi, Mun-Sik Kim, Dong Wook Lee, Junsik Lee, and Oscar Han "Investigation of Cr defect in high Cr load logic mask", Proc. SPIE 5446, Photomask and Next-Generation Lithography Mask Technology XI, (20 August 2004); https://doi.org/10.1117/12.557677
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Chromium

Logic

Etching

Dry etching

Photomasks

Scanning electron microscopy

Image processing

RELATED CONTENT

Resist process optimization for a DUV laser pattern generator
Proceedings of SPIE (December 17 2003)
Study of mask process development for EUVL
Proceedings of SPIE (August 20 2004)
Evaluation of loading effect of NLD dry etching
Proceedings of SPIE (July 19 2000)
Evaluation of dry etching and defect repair of EUVL mask...
Proceedings of SPIE (December 06 2004)
Mask CD correction method using dry-etch process
Proceedings of SPIE (October 20 2006)
Two-step etching process for small-size pattern
Proceedings of SPIE (September 01 1998)

Back to Top