Paper
5 December 2005 Network on electro-optical printed circuit board
Author Affiliations +
Proceedings Volume 6022, Network Architectures, Management, and Applications III; 602203 (2005) https://doi.org/10.1117/12.636417
Event: Asia-Pacific Optical Communications, 2005, Shanghai, China
Abstract
Greedy demand of high speed communication has made electrical interconnection on board a bottleneck. Electro-Optical Printed Circuit Board (EOPCB) was proposed to relieve the pressure by introducing an optical layer to common printed circuit board. Nowadays, most of the proposed EOPCB solutions focused on the design of optical transceiver structure and optical interconnection was used directly to replace high speed electrical interconnection by employing transceiver arrays. This approach would need many VCSEL-PIN pairs for a single high speed chip on board, thus increase the cost and also decrease the efficiency of optical interconnection. To defeat the weakness, a network approach, where only one VCSEL-PIN pair is required for a chip, is proposed in this paper. A novel Optoelectronic integrated circuit (OEIC) architecture is introduced to make this network approach possible.
© (2005) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Yonghua Feng, Fengguang Luo, Min Zhang, Jing Yuan, and Mingcui Cao "Network on electro-optical printed circuit board", Proc. SPIE 6022, Network Architectures, Management, and Applications III, 602203 (5 December 2005); https://doi.org/10.1117/12.636417
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Photonic integrated circuits

Waveguides

Transceivers

Optical interconnects

Interfaces

Vertical cavity surface emitting lasers

Electro optics

Back to Top