Tuning of superconducting nanowire single-photon detector parameters for VLSI circuit testing using time-resolved emission

A. Bahgat Shehata; F. Stellari

doi:10.1117/12.2079985

8 February 2015 Tuning of superconducting nanowire single-photon detector parameters for VLSI circuit testing using time-resolved emission

A. Bahgat Shehata, F. Stellari

Author Affiliations +

Proceedings Volume 9370, Quantum Sensing and Nanophotonic Devices XII; 93702Z (2015) https://doi.org/10.1117/12.2079985
Event: SPIE OPTO, 2015, San Francisco, California, United States

Abstract

Time-Resolved Emission (TRE) is a truly non-invasive technique based on the detection of intrinsic light emitted by integrated circuits that is used for the detection of timing related faults from the backside of flip-chip VLSI circuits. Single-photon detectors with extended sensitivity in the Near Infrared (NIR) are used to perform time-correlated single-photon counting measurements and retrieve the temporal distribution of the emitted photons, thus identifying gates switching events. The noise, efficiency and jitter performance of the detector are crucial to enable ultra-low voltage waveform sensitivity. For this reason, cryogenically cooled Superconducting Nanowire Single-Photon Detectors (SNSPDs) offer superior performance compared to state-of-the-art Single-Photon Avalanche Diodes (SPADs). In this paper we will discuss how detector front-end electronics parameters, such as bias current, RF attenuation and comparator threshold, can be tailored to optimize the measurement Signal-to-Noise Ratio (SNR), defined as the ratio between the switching emission peak amplitude and the standard deviation of the noise in the time interval in which there are no photons emitted from the circuit. For example, reducing the attenuation and the threshold of the comparator used to detect switching events may lead to an improvement of the jitter, due to the better discrimination of the detector firing, but also a higher sensitivity to external electric noise disturbances. Similarly, by increasing the bias current, both the detection efficiency and the jitter improve, but the noise increases as well. For these reasons an optimization of the SNR is necessary. For this work, TRE waveforms were acquired from a 32 nm Silicon On Insulator (SOI) chip operating down to 0.4 V using different generations of SNSPD systems.

Citation Download Citation

A. Bahgat Shehata and F. Stellari "Tuning of superconducting nanowire single-photon detector parameters for VLSI circuit testing using time-resolved emission", Proc. SPIE 9370, Quantum Sensing and Nanophotonic Devices XII, 93702Z (8 February 2015); https://doi.org/10.1117/12.2079985

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE

Includes PDF, HTML & Video, when available