15 December 2016 Contour metrology using critical dimension atomic force microscopy
Ndubuisi G. Orji, Ronald G. Dixson, Boon Ping Ng, András E. Vladár, Michael T. Postek
Author Affiliations +
Abstract
The critical dimension atomic force microscopy (CD-AFM) has been proposed as an instrument for contour measurement and verification since its capabilities are complementary to the widely used scanning electron microscopy (SEM). Although data from CD-AFM are three dimensional (3-D) in structure, the planar two-dimensional data required for contour metrology are not easily extracted from CD-AFM data. This is largely due to the limitations of the CD-AFM method for controlling the tip position and scanning, in which the relevant sidewall data are only obtained in one lateral axis. To use CD-AFM for contour metrology, the extracted profiles must include actual sidewall data from both lateral axes. Using two images acquired from orthogonal scan directions, profile extraction, and a method to combine those profiles, a technique for obtaining contours with the CD-AFM is developed. The main sources of error for this technique are described. The contours derived from CD-AFM were compared with those obtained using the SEM. Our results show that CD-AFM has the potential to make important contributions to semiconductor contour metrology.
Ndubuisi G. Orji, Ronald G. Dixson, Boon Ping Ng, András E. Vladár, and Michael T. Postek "Contour metrology using critical dimension atomic force microscopy," Journal of Micro/Nanolithography, MEMS, and MOEMS 15(4), 044006 (15 December 2016). https://doi.org/10.1117/1.JMM.15.4.044006
Published: 15 December 2016
Lens.org Logo
CITATIONS
Cited by 6 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Metrology

Scanning electron microscopy

Atomic force microscopy

Error analysis

Calibration

3D metrology

Image segmentation

Back to Top