12 February 2018 Design, modeling, and fabrication of crab-shape capacitive microphone using silicon-on-isolator wafer
Bahram Azizollah Ganji, Sedighe Babaei Sedaghat, Alberto Roncaglia, Luca Belsito, Reza Ansari
Author Affiliations +
Abstract
This paper presents design, modeling, and fabrication of a crab-shape microphone using silicon-on-isolator (SOI) wafer. SOI wafer is used to prevent the additional deposition of sacrificial and diaphragm layers. The holes have been made on diaphragm to prevent back plate etching. Dry etching is used for removing the sacrificial layer, because wet etching causes adhesion between the diaphragm and the back plate. Crab legs around the perforated diaphragm allow for improving the microphone performance and reducing the mechanical stiffness and air damping of the microphone. In this structure, the supply voltage is decreased due to the uniform deflection of the diaphragm due to the designed low-K (spring constant) structure. An analytical model of the structure for description of microphone behavior is presented. The proposed method for estimating the basic parameters of the microphone is based on the calculation of the spring constant using the energy method. The microphone is fabricated using only one mask to pattern the crab-shape diaphragm, resulting in a low-cost and easy fabrication process. The diaphragm size is 0.3  mm×0.3  mm, which is smaller than the conventional microelectromechanical systems capacitive microphone. The results show that the analytical equations have a good agreement with measurement results. The device has the pull-in voltage of 14.3 V, a resonant frequency of 90 kHz, an open-circuit sensitivity of 1.33  mV/Pa under bias voltage of 5 V. Comparing with previous works, this microphone has several advantages: SOI wafer decreases the fabrication process steps, the microphone is smaller than the previous works, and crab-shape diaphragm improves the microphone performances.
© 2018 Society of Photo-Optical Instrumentation Engineers (SPIE) 1932-5150/2018/$25.00 © 2018 SPIE
Bahram Azizollah Ganji, Sedighe Babaei Sedaghat, Alberto Roncaglia, Luca Belsito, and Reza Ansari "Design, modeling, and fabrication of crab-shape capacitive microphone using silicon-on-isolator wafer," Journal of Micro/Nanolithography, MEMS, and MOEMS 17(1), 015002 (12 February 2018). https://doi.org/10.1117/1.JMM.17.1.015002
Received: 5 October 2017; Accepted: 19 January 2018; Published: 12 February 2018
Lens.org Logo
CITATIONS
Cited by 3 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Semiconducting wafers

Silicon

Microelectromechanical systems

Etching

Photomasks

Acoustics

Photoresist materials

RELATED CONTENT


Back to Top