1 February 2001 Zero and direction reference mark based on phase jump
Weidong Zhou, Lilong Cai
Author Affiliations +
A perfect zero reference mark is essential for an incremental measurement system to achieve absolute coordinates. An optical zero reference mark based on a phase jump is presented. The zero reference position signal is achieved using two same-frequency focused beams to cross an edge on a simple scale. The phase difference between these two beams is prefixed at 180 deg. The use of a heterodyne interference technique enables the phase jump to be detected. The zero signal is a phase jump of 180 deg, and the theoretical slope of the phase jump is infinite. Because the phase differences of the signal on two sides of the phase jump are 180 deg, the direction can be also obtained. The zero signal is high in resolution and has excellent disturbance resistance. At the same time, the zero reference mark can be naturally integrated with a commercially available positioning system. Both the theoretical design and experimental verification are conducted and the results are presented in detail.
©(2001) Society of Photo-Optical Instrumentation Engineers (SPIE)
Weidong Zhou and Lilong Cai "Zero and direction reference mark based on phase jump," Optical Engineering 40(2), (1 February 2001). https://doi.org/10.1117/1.1336525
Published: 1 February 2001
Lens.org Logo
CITATIONS
Cited by 3 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Glasses

Prisms

Signal detection

Coating

Interferometers

Chromium

Light sources

Back to Top