Since Krupke et.al. proposed and demonstrated pumping alkali atoms using diode lasers in
2003, there has been lot of interest in the diode pumped alkali laser (DPAL) systems. Several
researchers have been able to scale the DPAL system to powers in the tens of watts. We have
conducted a systems-level, weight-scaling study of a notional medium power, CW DPAL system.
Three different modes of operation are considered: (i) very high pressure operation (over 25
atmospheres of He) in which the absorption and emission lines of the alkali atoms are broadened
sufficiently to allow for efficient pumping with off-the-shelf diodes that have line width of 2 to 3
nm, (ii) intermediate pressure regime (~ 5 atmospheres) that requires diodes that are line narrowed
to ~0.4 nm, and (iii) low pressure operation (~ 1 atmosphere) that requires diodes that are line
narrowed to < 0.1 nm for efficient pumping of pump radiation into the alkali vapor. In the latter two
cases some amount of methane, ethane, or some other gas would be needed to mix the two upper
states rapidly; while in the first case, helium is used to broaden the transition and to mix the upper
states. We have considered closed-cycle transverse flowing systems with the transverse length
limited by medium inhomogeneity caused by heat deposition into the gas. Weight models have been
developed for each of the following sub-systems: Pump Diodes, Fluid Flow System, Thermal
Management System, Optics and Diagnostics System, Instrumentation & Control System, and
Electrical Power system. The results of our weight estimates for a notional 100 kW DPAL system
are presented.
Singlet oxygen generators are multiphase flow chemical reactors that produce energetic oxygen to be used as a fuel for
chemical oxygen iodine lasers. In this paper, a theoretical model of the generator is presented that consists of a twophase
reacting flow model that treats both the gas phase and dispersed (liquid droplet) phase. The model includes the
discretization over droplet size distribution as well. Algorithms for the robust solution of the large set of coupled, nonlinear,
partial differential equations enable the investigation of a wide range of operating conditions and even geometric design
choices.
Since the initial demonstration of chemical oxygen iodine lasers in 1977, researchers have realized that the heart of
the COIL system is the singlet oxygen generator. This drives the performance of the system in terms of output
power, mass efficiency, engineering complexity, reliability and maintainability. For this reason the singlet oxygen
generator has been the focus of intense research and development efforts over the last 30 years. This paper reports
on the history of singlet oxygen generators - starting with the simple sparger design used in the initial COIL
demonstration and ending with current jet or droplet generators used in laboratories around the world. The relative
performance of the different generator types will naturally lead to performance goals for the research efforts of the
future.
A critical parameter for understanding the performance of Chemical Oxygen Iodine Lasers is the yield of singlet oxygen produced by the generator. Off-Axis Integrated Cavity Output Spectroscopy (Off-Axis ICOS) has been utilized to measure the absolute density of both ground-state and singlet oxygen in the cavity of a COIL laser.
KEYWORDS: Hydrogen fluoride lasers, Chemical species, 3D modeling, Energy transfer, Turbulence, Fluorine, Laser systems engineering, Chemical reactions, Molecules, Laser resonators
The small signal gain of a small-scale HF overtone laser was measured using a sub-Doppler tunable diode laser system. The spatially resolved, two-dimensional small signal gain maps that were generated show a highly inhomogeneous gain medium indicating the dominant role played by mixing of the H2 and F streams in HF laser performance. The measured gain data were analyzed with the aid of a two-dimensional computational fluid dynamics model. The results show that reactant mixing mechanisms have a large effect on the gain averaged over a vertical profile while kinetic rate mechanisms, including reaction rate constants and reactant concentration, have a greater effect on the maximum system gain.
The uncertainty in both the fluorine atom concentration and the gain length has inhibited the development of accurate and device independent models of HF overtone lasers. Furthermore, previous methods of measuring the small signal gain were cumbersome and could not easily generate spatial maps of the gain in the cavity. Experimental techniques have been developed to directly measure the concentration of fluorine atoms, the gain length and the small signal gain in a hydrogen fluoride 5 cm slit nozzle laser. A gas phase titration technique was utilized to measure the fluorine atom concentration using HCl as the titrant. The gain length was measured using a pitot probe to locate the interface of the primary flow with the high Mach number shroud flows. A tunable diode laser was utilized to perform small signal gain measurements on HF overtone (ν=2→0) transitions.
A review of recent advances in chemical laser technology is presented. New technology and concepts related to the Chemical Oxygen Iodine Laser (COIL), All Gas-phase Iodine Laser (AGIL), and HF Overtone Laser are discussed.
Overtone small signal gain data measured while operating a small-scale HF laser saturated on the fundamental transitions are compared with fundamental lasing output spectra and spontaneous overtone emission spectra measured orthogonal to the lasing axis. In all cases, the data are consistent with an equilibrium rotational distribution. These results are discussed in terms of their applicability to the question of rotational nonequilibrium in cw HF lasers.
KEYWORDS: Hydrogen fluoride lasers, Chemical species, Diffusion, Data modeling, Fluorine, Laser systems engineering, Turbulence, 3D modeling, Chemical reactions, Computer simulations
The small signal gain of a small-scale HF overtone laser was measured using a sub-Doppler tunable diode laser system. Measurements of reactant concentration, flow velocity and gain length were also made. The spatially resolved, two-dimensional small signal gain and temperature maps that were generated show a highly inhomogeneous gain medium indicating the dominant role played by mixing of the H2 and F streams in HF laser performance. The measured gain and temperature data were analyzed with the aid of a two-dimensional computational fluid dynamics model. The results show that reactant mixing mechanisms have a large effect on the gain averaged over a vertical profile while kinetic rate mechanisms, including reaction rate constants and reactant concentration, have a greater effect on the maximum system gain.
Access to the requested content is limited to institutions that have purchased or subscribe to SPIE eBooks.
You are receiving this notice because your organization may not have SPIE eBooks access.*
*Shibboleth/Open Athens users─please
sign in
to access your institution's subscriptions.
To obtain this item, you may purchase the complete book in print or electronic format on
SPIE.org.
INSTITUTIONAL Select your institution to access the SPIE Digital Library.
PERSONAL Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.