Paper
26 April 2016 Contrast optimization for 0.33NA EUV lithography
Jo Finders, Sander Wuister, Thorsten Last, Gijsbert Rispens, Eleni Psari, Jan Lubkoll, Eelco van Setten, Friso Wittebrood
Author Affiliations +
Abstract
0.33 NA EUV lithography is expected to be introduced into High Volume Manufacturing at k1 values of approximately 0.4...0.5. This is significantly larger than state of the art immersion lithography which can operate at k1 of 0.3. We investigated the impact of contrast enhancement on the imaging properties of Contact Holes and Lines and Spaces. Contrast was adjusted by changing the illumination properties pupil fill ratio and center incidence angle. We found a strong improvement of the local Critical Dimension control: line width variation for Lines and Spaces and hole to hole CD variations for arrays of contact holes. For all features we found a similar dependency on contrast. As the local Critical Dimension variations contribute significant to Edge Placement Error budgets, we foresee the implementation of contrast enhancements already at moderate k1 values around 0.4.
© (2016) COPYRIGHT Society of Photo-Optical Instrumentation Engineers (SPIE). Downloading of the abstract is permitted for personal use only.
Jo Finders, Sander Wuister, Thorsten Last, Gijsbert Rispens, Eleni Psari, Jan Lubkoll, Eelco van Setten, and Friso Wittebrood "Contrast optimization for 0.33NA EUV lithography", Proc. SPIE 9776, Extreme Ultraviolet (EUV) Lithography VII, 97761P (26 April 2016); https://doi.org/10.1117/12.2220036
Lens.org Logo
CITATIONS
Cited by 8 scholarly publications.
Advertisement
Advertisement
RIGHTS & PERMISSIONS
Get copyright permission  Get copyright permission on Copyright Marketplace
KEYWORDS
Nanoimprint lithography

Extreme ultraviolet lithography

Critical dimension metrology

Extreme ultraviolet

Neodymium

Tantalum

Line width roughness

Back to Top