Novel alignment technique for 0.1-micron lithography using the wafer   rear surface and canceling tilt effect

Souichi Katagiri; Shigeo Moriyama; Tsuneo Terasawa

doi:10.1117/12.145957

1 October 1993 Novel alignment technique for 0.1-μm lithography using the wafer rear surface and canceling tilt effect

Souichi Katagiri, Shigeo Moriyama, Tsuneo Terasawa

Author Affiliations +

Optical Engineering, Vol. 32, Issue 10, (October 1993). https://doi.org/10.1117/12.145957

Abstract

A new wafer rear surface alignment (RSA) technique using a rear surface and canceling tilt effect (RECT) for wafer steppers is proposed. RECT alignment can provide the alignment accuracies of less than 0.03 μm (3σ) that are required for 0.1-μm lithography. The accuracy is almost the same as the resolution limit in the alignment sensor; therefore, position detection errors, which are caused by multi-interference in resist films and the asymmetric profile of marks deformed during manufacturing processes, must be decreased until they can be neglected. The concept of wafer RSA has provided a breakthrough to obtain higher overlay accuracy by fabricating alignment marks on the wafer rear surface. RSA, however, has the disadvantage of a position detection error ε caused by a thickness between the wafer surface and the rear surface, which strongly depends on the wafer tilt. To overcome this problem, RECT consists of two-beam-illumination optics to cancel the error ε. The diffracted beams that are reflected from two separate points on the grating mark include information on both mark positions and light-path difference due to wafer tilt. Thus, the wafer-tilt-induced error can be automatically canceled by processing this information. In an experiment using a six-axis fine positioning stage, it was proven that alignment accuracy can be minimized to as small as 0.015 μm (3σ) for a wafer-tilt angle range of ±50 μrad.

Citation Download Citation

Souichi Katagiri, Shigeo Moriyama, and Tsuneo Terasawa "Novel alignment technique for 0.1-μm lithography using the wafer rear surface and canceling tilt effect," Optical Engineering 32(10), (1 October 1993). https://doi.org/10.1117/12.145957

Published: 1 October 1993

ACCESS THE FULL ARTICLE

INSTITUTIONAL
Select your institution to access the SPIE Digital Library.

SELECT YOUR INSTITUTION

PERSONAL
Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.

PERSONAL SIGN IN

No SPIE Account? Create one

;

PURCHASE THIS CONTENT

SUBSCRIBE TO DIGITAL LIBRARY

50 downloads per 1-year subscription

Members: $195

Non-members: $335 ADD TO CART

25 downloads per 1 - year subscription

Members: $145

Non-members: $250 ADD TO CART

PURCHASE SINGLE ARTICLE