The process of computed axial lithography (CAL) has been established as one of the fastest available photopolymer 3D printing methods, offering smooth surfaces (r.m.s. surface roughness as low as 6 nm) and the ability to process high-viscosity precursor materials (100,000 cP demonstrated). Recently we showed successful printing of microscale geometries into dispersions of silica nanoparticles in a refractive-index-matched photopolymer. After exposing the 3D geometry via patterned tomographic illumination the material is debinded and sintered. In this way, external features of 50 µm and internal channels of 150 µm diameter have been achieved. This processing technique offers a promising route to production of 3D glass microfluidic devices and complex monolithic micro-optical devices. We will describe the status of optics fabrication via CAL. We will also consider the influence of light scattering on spatial resolution and possible ways of addressing this effect.
Volumetric additive manufacturing is a novel 3D printing method to form parts in a single exposure, in contrast to traditional stereolithography 3D printing which builds parts layer-by-layer. Photopolymerizable resin is exposed with grayscale images from different angles over 360 degrees to deliver a 3D distribution of light energy which cures the resin to form the desired part. The exposure images are calculated using computed tomography (CT), the same principles which are used to convert X-ray images obtained during a computerized axial tomography (CAT) scan to reconstruct a 3D volume of the patient. A digital micromirror device is used to project the sequence of calculated exposure images into a cylindrical vial of resin as it is rotated thus exposing over 360 degrees. The polymerization kinetics of the resin, the alignment of the resin vial to the projected images, and the uniformity of the illumination field are all tightly coupled together and must all be understood and controlled to generate quality parts. Projecting a good image is challenging as the vial and resin are essentially a strong cylindrical lens located at the image plane, and the desired build space is not a plane but a volume. We perform an analysis of the cylindrical lensing on the image quality (and thus the print quality) and investigate methods to correct for the lensing. We demonstrate different methods to improve print quality and discuss the benefits and limitations of each technique.
Access to the requested content is limited to institutions that have purchased or subscribe to SPIE eBooks.
You are receiving this notice because your organization may not have SPIE eBooks access.*
*Shibboleth/Open Athens users─please
sign in
to access your institution's subscriptions.
To obtain this item, you may purchase the complete book in print or electronic format on
SPIE.org.
INSTITUTIONAL Select your institution to access the SPIE Digital Library.
PERSONAL Sign in with your SPIE account to access your personal subscriptions or to use specific features such as save to my library, sign up for alerts, save searches, etc.